GE-IP | 9030 | GE Fanuc 90-30 GE-IP PLC

IC693MDL231 Image


  • Availability: In Stock Ships Today!
  • Units in Stock: Immediate Availablity: 6 Units!
  • Call for best Pricing+ 1 919 680 1773
  • Manufacturer: GE-IP
  • Description: 240 Volts ac Isolated Input
  • Weight: 1 lbs :: ≈ 1 kgs
  • Warranty: 1 Years
  • Product Revisions Available:
  • Other Available Revisions of the IC693MDL231 : A, B, C, D, E, F, G, H, I, J, K, L, M, N, O, P, Q, R, S, T, U, V, W, X, Y, Z,

Product Manual Excerpt

240 Volt AC Isolated Input, 8 Point IC693MDL231 The 240 volt AC Isolated Input module for the Series 90-30 Programmable Logic Controller provides 8 isolated input points, each with a common power input terminal. The input circuits are reactive (resistor/capacitor) inputs. Current into an input point results in a logic 1 in the input status table (%I). Input characteristics are compatible with a wide range of user-supplied input devices, such as pushbuttons, limit switches, and electronic proximity switches. Power to operate the field devices must be supplied by the user. This module requires an AC power source, it cannot be used with a DC power source. LED indicators which provide the ON/OFF status of each point are located at the top of the module. This LED block has a horizontal row with eight green LEDs labeled A1 through 8 (points 1 through 8). An insert goes between the inside and outside surface of the hinged door. The surface towards the inside of the module (when the hinged door is closed) has circuit wiring information, and circuit identification information can be recorded on the outside surface. The outside left edge of the insert is color-coded red to indicate a high-voltage module. This module can be installed in any I/O slot of a 5 or 10-slot baseplate in a Series 90-30 PLC system. Table 6-2. Specifications for IC693MDL231 Rated Voltage 240 volts AC, 50/60 Hz Input Voltage Range 0 to 264 volts AC, 50/60 Hz Inputs per Module 8 (each input point has a separate common) Isolation 1500 volts RMS between field side and logic side 500 volts RMS between inputs Input Current 15 mA (typical) at rated voltage Input Characteristics: On-state Voltage 148 to 264 volts AC Off-state Voltage 0 to 40 volts AC On-state Current 6 mA minimum Off-state Current 2.2 mA maximum On response Time 30 ms maximum Off response Time 45 ms maximum Power Consumption 60 mA (all inputs on) from 5 volt bus on backplane Refer to Appendix B for product standards and general specifications. 6 6-4 Series 90-30 PLC I/O Module Specifications July 2000 GFK-0898F IC693MDL231 Input Module Field Wiring Information The following figure provides wiring information for connecting user supplied input devices and power source to the 240 volt AC Isolated input module. Note that since each input is isolated (separate) from each of the other inputs, each input can be powered by a separate AC power source.