IC693CPU313 | IC693CPU313S

GE-IP | 9030 | GE Fanuc 90-30 GE-IP PLC


IC693CPU313 | IC693CPU313S

  • Availability: In StockShips Today!
  • Units in Stock: Immediate Availablity: 4 Units!
  • Call for best Pricing+ 1 919 680 1773
  • Manufacturer: GE-IP
  • Description: GE Fanuc Series 90-30 5 Slot Rack with Turbo CPU in base 1k Registers
  • Weight: 1 lbs :: ≈ 1 kgs
  • Warranty: 1 Years
  • Product Revisions Available:
  • Other Available Revisions of the IC693CPU313 : A, B, C, D, E, F, G, H, I, J, K, L, M, N, O, P, Q, R, S, T, U, V, W, X, Y, Z, -AA, -AB, -AC, -AE,

Product Manual Excerpt

Removing a Terminal Board To remove a terminal board: 1. Open the plastic terminal board cover. 2. Push up on jacking lever to release the terminal block (Figure 2-4). 3. Grasp pull-tab toward you until contacts have separated from module housing and hook has disengaged for full removal (Figure 2-5). JACKING LEVER a43061 Figure 2-4. Releasing the Terminal Block PULL TAB a43715 Figure 2-5. Removing a Terminal Board 2 2-5 GFK-1028 Chapter 2 Installation and Wiring Field Wiring Considerations Warning You should calculate the maximum current for each wire and observe proper wiring practices. Failure to do so could cause injury to personnel or damage to equipment. It is recommended that the following procedures be followed when routing and connecting field wiring from user devices to the PLC or to output devices to be controlled by the PLC. D All low level signal wires should be run separately from other field wiring. D AC power wiring should be run separately from DC field wiring. D Field wiring should not be routed close to any device that could be a potential source of electrical interference. D If severe noise problems are present, additional power supply filtering or an isolation transformer may be required. D Ensure that proper grounding procedures are followed to minimize potential safety hazards to personnel. D Label all wires to and from I/O devices. Record circuit identification numbers or other pertinent data on the inserts for the module’s faceplate door).

Warning: include_once(/js/tracking.php): failed to open stream: No such file or directory in /var/www/series/revision.php on line 248 Warning: include_once(): Failed opening '/js/tracking.php' for inclusion (include_path='.:/usr/share/php:/usr/share/pear') in /var/www/series/revision.php on line 248