IC693APU300 | IC693APU300J

GE-IP | 9030 | GE Fanuc 90-30 GE-IP PLC

product-image

IC693APU300 | IC693APU300J

  • Availability: In StockShips Today!
  • Units in Stock: Immediate Availablity: 4 Units!
  • Call for best Pricing+ 1 919 680 1773
  • Manufacturer: GE-IP
  • Description: GE Fanuc Series 90-30 High Speed Counter
  • Weight: 1 lbs :: ≈ 1 kgs
  • Warranty: 1 Years
  • Product Revisions Available:
  • Other Available Revisions of the IC693APU300 : A, B, C, D, E, F, G, H, I, J, K, L, M, N, O, P, Q, R, S, T, U, V, W, X, Y, Z,

Product Manual Excerpt

Operational Notes  Backplane grounding bar should be used to connect shield ground of the input cable. If shield ground connection is necessary, the module should be installed on a backplane which support s a grounding bar.  Were both COMREQ and memory mapping method s are use d to update same variable, the result will be indeterminate , as the last command accepted by the module will be that which will affect the outcome .  During Indirect firmware update process, if the operation is disrupted (e.g. power cycle or the serial cable is disconnected) module goes into boot mode (S1 and S2 LEDs blink in unison continuously). If the module is configured as Classic mode in the hardware configuration, then restart the firmware update process to complete the firmware upgrade. If the module is configured as Enhanced mode, then Loss of IO Module fault will be logged in the IO Fault table. To recover from this situation please follow below steps: a. Clear the hardware configuration from CPU memory – RAM and Flash(if the hardware configuration is stored in Flash) b. Power cycle the system c. Restart the firmware update process. d. After the firmware update is complete, restore the hardware configuration in the CPU memory.  IC693APU300 - M x and later modules do not support the 90 - 30 Hand Held programmer

Warning: include_once(/js/tracking.php): failed to open stream: No such file or directory in /var/www/series/revision.php on line 248 Warning: include_once(): Failed opening '/js/tracking.php' for inclusion (include_path='.:/usr/share/php:/usr/share/pear') in /var/www/series/revision.php on line 248